Skip to content
Equipment

Teledyne Showcases 32K Camera and 3D Metrology at SEMICON Europa 2026

Teledyne Showcases 32K Camera and 3D Metrology at SEMICON Europa

Teledyne Vision Solutions is demonstrating two precision imaging and inspection platforms at SEMICON Europa 2026, held from November 10 to 13 at Messe München in Munich, Germany. Exhibiting at Hall C2, Stand 136, the company is running live demonstrations of its Linea™ ML 32K line scan camera and the Z3™ 3D Measurement System, highlighting high-throughput optical inspection and dimensional metrology designed for front-end wafer fabrication and backend advanced packaging lines.

As semiconductor manufacturers scale leading-edge logic nodes and multi-die artificial intelligence hardware, inline defect detection and dimensional verification have become essential to protecting production yields. Traditional inspection tools often force chipmakers to balance spatial resolution against wafer throughput, creating inspection bottlenecks on high-volume production lines. Teledyne’s live showcase demonstrates how high-speed line scanning and sub-micron 3D profiling address these process control requirements without slowing cleanroom workflows.

At the core of the two-dimensional optical demonstration is the Linea ML 32K, which Teledyne identifies as the world’s first true 32K line scan camera. Built on the company’s established Linea camera architecture, the system combines 32K horizontal resolution with 2.5 µm pixel sizes and line rates reaching up to 150 kHz. During the exhibition, Teledyne is demonstrating single-pass inspection of a full 300 mm semiconductor wafer at 10 µm resolution. By capturing an entire 300 mm wafer diameter in a single linear scan rather than requiring multiple overlapping passes, the camera reduces mechanical stage indexing overhead and simplifies optical integration for equipment builders. The camera also supports multiline operation, high dynamic range (HDR), and time delay and integration (TDI) imaging modes to maintain signal-to-noise performance across low-contrast wafer surfaces.

Alongside 2D wafer scanning, Teledyne is presenting the Z3 3D Measurement System, a combined 3D metrology and 2D inspection platform engineered for inline process control. The Z3 delivers spatial resolution down to 1.25 µm and height repeatability of up to 35 nanometres while operating at throughput speeds of up to two seconds per wafer. Built to support the stringent structural tolerances of AI semiconductor packaging, the tool executes metrology across micro ball grid arrays (BGA), solder bumps, and copper pillars on individual dies, wafers, or stretch frames.

The Z3 system also addresses critical vertical interconnect and bonding challenges in heterogeneous integration. Its measurement capabilities cover through-glass vias (TGV), through-silicon vias (TSV), wafer-to-wafer bonding interfaces, substrate flatness, coplanarity, and surface defect analysis. Maintaining strict coplanarity and bump height uniformity is vital in 2.5D and 3D chiplet stacking, where minor dimensional deviations can lead to open circuits or mechanical delamination during bonding. By combining high-speed 3D surface profiling with inline defect verification, Teledyne provides semiconductor equipment manufacturers and fabs with actionable process data to maintain quality assurance across advanced packaging and wafer-level production.

About the Author

Leave a Reply

Your email address will not be published. Required fields are marked *

14 + nine =